KP 2000 Hard Disk/Floppy Controller Settings and Configuration

Data bus:	16-bit, ISA
Size:	Full-length, full-height card
Hard drive supported:	Two MFM ST506/412 drives
Floppy drives supported:	Two 360KB, 720KB, 1.2MB, or 1.44MB drives

CONNECTIONS
Function	Location
4-pin connector - drive active LED	J1
20-pin data cable connector - drive 2	J2
20-pin data cable connector - drive 1	J3
34-pin control cable connector - hard drive	J4
34-pin control cable connector - floppy drive	J5

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	AT-type 3.50in floppy drive installed	JP2	pins 1 & 2 closed
	PS/2-type 3.50in floppy drive installed	JP2	pins 2 & 3 closed
»	Single speed floppy drive selected	JP5	open
	Dual speed floppy drive selected	JP5	closed
»	HDD Write Precompensation = 125ns	JP6	open
	HDD Write Precompensation = 187ns	JP6	closed
»	HDD address = 1F0h	JP7	pins 1 & 2 closed
	HDD address = 170h	JP7	pins 2 & 3 closed
»	Floppy drive address = 3F2, 3F4-3F7h	JP8	pins 1 & 2 closed
	Floppy drive address = 372, 374-377h	JP8	pins 2 & 3 closed

FLOPPY DRIVE
Setting		JP3	JP4
»	Enabled	closed	open
	Disabled	open	closed

FLOPPY DRIVE OPTIONS
Drive A		Drive B	JP1
»	5.25in	None	pins 1 & 2 closed
	5.25in	5.25in	pins 1 & 2 closed
	5.25in	3.50in	pins 2 & 3 closed
	3.50in	3.50in	pins 2 & 3 closed
	3.50in	None	pins 2 & 3 closed