T130 Hard Disk/Floppy Controller Settings and Configuration

Data bus:	8-bit, ISA
Size:	Half-length, full-height card
Hard drive supported:	Up to seven SCSI devices
Floppy drives supported:	None

CONNECTIONS
Function	Location
DB25 SCSI connector - external	J1
50-pin SCSI connector - internal	J2
4-pin connector - Drive Activity LED	J4

I/O PORT ADDRESS
Address	SW1/switch 1	SW1/switch 2
350h	off	off
340h	off	on
250h	on	off
240h	on	on

BIOS ADDRESS - SW1
Address	SW1/switch 3	SW1/switch 4	SW1/switch 5
Disabled	off	off	off
CA00h	off	off	on
CE00h	off	on	off
DA00h	off	on	on
DE00h	on	off	off
Reserved	on	off	on
Reserved	on	on	off
Reserved	on	on	on

INTERRUPT REQUEST
IRQ		JP3/jumper 1	JP3/jumper 2	JP3/jumper 3
»	Disabled	open	open	open
	IRQ3	closed	open	open
	IRQ5	open	cosed	open
	IRQ7	open	open	closed

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	BIOS enabled	SW1/switch 6	off
	BIOS disabled	SW1/switch 6	on
»	Factory configured - do not alter	SW1/switch 7	off
»	Factory configured - do not alter	SW1/switch 8	off
»	Zero Wait State disabled	JP2	open
	Zero Wait State enabled	JP2	closed