DC4030VL-2 (REV.2) Hard Disk/Floppy Controller Settings and Configuration

Data bus:	32-bit, VL-bus
Size:	Three/quarter-length, full-height card
Hard drive supported:	Four IDE (AT) interface drives
Floppy drives supported:	Four 360KB, 720KB, 1.2MB, 1.44MB, or 2.88MB drives

CONNECTIONS
Function	Location
40-pin IDE (AT) Interface connector - IDE 0, 1	J1
40-pin IDE (AT) Interface connector - IDE 2, 3	J2
34-pin control cable connector - floppy drive - Floppy 0, 1	J3
34-pin control cable connector - floppy drive - Floppy 2, 3	J4
4-pin connector - drive active LED	JP1

USER CONFIGURABLE SETTINGS
Function		Location	Setting
»	Factory configured - do not alter	JP2	pins 2 & 3 closed
»	Floppy drive enabled	JP3	pins 1 & 2 closed
	Floppy drive disabled	JP3	pins 2 & 3 closed

MISCELLANEOUS TECHNICAL NOTES

At least one pair of SIMMs of equal memory size (256KB, 1MB or 4MB of 70ns or faster) must be installed in Bank 0 for the DC4030VL-2 to function.