DTC2132D Hard Disk/Floppy Controller Settings and Configuration
DATA TECHNOLOGY CORPORATION
DTC2132D
Data bus: | 32-bit PCI |
Size: | Half-length, half-height card |
Hard drive supported: | Four IDE(AT) or EIDE interface drives |
Floppy drives supported: | None |
CONNECTIONS | |
Function | Location |
10-pin DTC-1415 ISA B Interrupt adapter connector | J1 |
4-pin connector - drive active LED | J2 |
40-pin connector - primary IDE(AT) interface | J3 |
40-pin connector - secondary IDE(AT) interface | J4 |
Note: Connector J1 is intended for use in systems that do not support redirected PCI interrupts. | |
USER CONFIGURABLE SETTINGS | |||
Function | Location | Setting | |
| » | Primary port INTA redirect to IRQ14 | W1/pins 1 & 3 | closed |
| Primary port INTB redirect to IRQ14 | W1/pins 2 & 4 | closed | |
| Primary port INTC redirect to IRQ14 | W1/pins 3 & 5 | closed | |
| Primary port INTD redirect to IRQ14 | W1/pins 4 & 6 | closed | |
| Secondary port INTA redirect to IRQ15, IRQ12 or IRQ11 | W2/pins 1 & 3 | closed | |
| Secondary port INTB redirect to IRQ15, IRQ12 or IRQ11 | W2/pins 2 & 4 | closed | |
| Secondary port INTC redirect to IRQ15, IRQ12 or IRQ11 | W2/pins 3 & 5 | closed | |
| Secondary port INTD redirect to IRQ15, IRQ12 or IRQ11 | W2/pins 4 & 6 | closed | |
| » | Fixed IDE address at power-up (1F0-1F7h) | W3 | closed |
| Relocatable IDE address at power-up | W3 | open | |
| » | IDE decode state disabled after reset | W4 | closed |
| IDE decode state enabled after reset | W4 | open | |
My Books
