WD8003E Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	8-bit ISA
Topology	Linear Bus
Wiring Type	RG-58A/U 50ohm coaxial AUI transceiver via DB-15 port
Boot ROM	Not Available

COMPATIBILITY MODE
Setting	W1A
Wait states disnabled	Open
Wait states enabled (6MHz AT)	Closed
Note:This jumper is ignored in an XT-class machine.

I/O BASE ADDRESS
Address		W1B	W1C	W1D	W1E
»	280h	Closed	Closed	Open	Closed
	2A0h	Open	Closed	Open	Closed
	2C0h	Closed	Open	Open	Closed
	2E0h	Open	Open	Open	Closed
	300h	Closed	Closed	Closed	Open
	320h	Open	Closed	Closed	Open
	340h	Closed	Open	Closed	Open

INTERRUPT SETTINGS
IRQ		W2A	W2B	W2C	W2D	W2E	W2F
	2	Closed	Open	Open	Open	Open	Open
»	3	Open	Closed	Open	Open	Open	Open
	4	Open	Open	Closed	Open	Open	Open
	5	Open	Open	Open	Closed	Open	Open
	6	Open	Open	Open	Open	Closed	Open
	7	Open	Open	Open	Open	Open	Closed

CABLE TYPE
Type		W3A-F
»	RG-58A/U 50ohm coaxial	Closed
	AUI transceiver via DB-15 port	Open

ETHERNET VERSION
Version		W4
»	10Base2 (for thin Ethernet) or IEEE 802.3 version 2 (for thick Ethernet)	Open
	IEEE 802.3 version 1 (for thick Ethernet)	Closed

SEGMENT LENGTH
Maximum Length		W5
»	185 meters	Closed
	300 meters	Open
Note:Segment length is the total length of cable between the two farthest cards on the segment. Each card on the segment must have this option set the same.