TOKEN-RING 16/4 ADAPTER II Network Card Settings and Configuration

NIC Type	Token-Ring
Transfer Rate	4/16Mbps
Data Bus	16-bit ISA
Topology	Ring
Wiring Type	Unshielded twisted pair Shielded twisted pair via DB-9 port
Boot ROM	Available

BOOT ROM ADDRESS AND I/O BASE ADDRESS
Boot ROM		I/O Address	SW1/1	SW1/2	SW1/3
	C0000h	86A0h	On	On	On
	C4000h	96A0h	Off	On	On
	C8000h	A6A0h	On	Off	On
»	CC000h	B6A0h	Off	Off	On
	D0000h	C6A0h	On	On	Off
	D4000h	D6A0h	Off	On	Off
	D8000h	E6A0h	On	Off	Off
	DC000h	F6A0h	Off	Off	Off

INTERRUPT REQUEST
IRQ		SW1/4	SW1/5
	2/9	On	On
	10	Off	On
	11	On	Off
»	15	Off	Off

WAIT STATE
Setting		SW1/6
»	Normal	On
	Additional wait states added to I/O cycle	Off
Note:If the card is installed in a fast computer, the card may need to slow down the I/O cycle by adding wait states.

COMPATIBILITY MODE
Setting		SW1/7
»	Disabled	On
	Enabled	Off
Note:On some systems the data bus timing is not truly IBM PC/AT compatible. If the card is not initializing, enabling compatibility mode may allow the card to operate properly.

BOOT ROM
Setting		SW1/8
»	Disabled	On
	Enabled	Off

DMA CHANNEL
Channel		SW1/9	SW1/10
»	Disabled	Off	Off
	DMA5	On	On
	DMA6	Off	On
	DMA7	On	Off

NETWORK SEGMENT SPEED
Speed		SW1/11
»	4Mbps	On
	16Mbps	Off
Note:All cards on the network segment must have this option set identically.

CABLE TYPE
Type		SW1/12
»	Shielded twisted pair	On
	Unshielded twisted pair	Off