MODEL 2100 Network Card Settings and Configuration

NIC Type	Ethernet
Transfer Rate	10Mbps
Data Bus	16-bit ISA
Topology	Linear bus
Wiring Type	RG58A/U 50ohm coaxial cable
Boot ROM	Available

WAIT STATE CONFIGURATION
Wait State(s)	W1
0 wait states	Open
1 wait state	Closed

CABLE TYPE
Type	W2-W9
AUI transceiver via DB-15	Pins 1 & 2 closed
RG58A/U 50ohm coaxial	Pins 2 & 3 closed

SIGNAL QUALITY ERROR CONFIGURATION
Mode		W1A
»	Signal quality error enabled	Pins 2 & 3 closed
	Signal quality error disabled	Pins 1 & 2 closed

DMA CHANNEL
Channel	W10	W11	W12	W13	W14	W15	W16	W17
DMA3	Closed	Open	Open	Open	Closed	Open	Open	Open
DMA5	Open	Closed	Open	Open	Open	Closed	Open	Open
DMA6	Open	Open	Closed	Open	Open	Open	Closed	Open
DMA7	Open	Open	Open	Closed	Open	Open	Open	Closed

BOOT ROM
Setting		W18
»	Disabled	Open
	Enabled	Closed

BASE I/O ADDRESS
Address		W19	W20
	300h	Closed	Closed
	320h	Closed	Open
»	340h	Open	Closed
	360h	Open	Open

INTERRUPT SETTINGS
IRQ	W21	W22	W23	W24
5	Open	Open	Closed	Open
10	Open	Closed	Open	Open
11	Open	Open	Open	Closed
15	Closed	Open	Open	Open