AT-MX300TX Network Card Settings and Configuration

Device Type	Transceiver
NIC Type	Ethernet
Maximum Onboard Memory	Unidentified
Boot ROM	Not available
Network Transfer Rate	10/100Mbps
Topology	Star
Wiring Type	Unshielded Twisted Pair
Data Bus	External

CONNECTIONS
Function	Label	Function	Label
40-pin MII interface	CN1	UTP connector (RJ-45)	CN2

BASE I/O ADDRESS SELECTION
Note:	A total of 32 base address settings are available. The switches are a binary representation of the decimal memory addresses. SW1/1 is the Most Significant Bit and switch SW1/5 is the Least Significant Bit. The switches decimal values are unidentified. (Off=1, On=0)

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
PWR	Unidentified	On	Power is on
PWR	Unidentified	Off	Power is off
FD	Unidentified	On	100Mbps: Transciever in full duplex mode 10Mbps: UTP receive data signals are correctly connected
FD	Unidentified	Off	100Mbps: Transciever not in full duplex mode 10Mbps: UTP receive data signals are not correctly connected
LNK	Unidentified	On	Network connection is good
LNK	Unidentified	Off	Network connection is broken
TX	Unidentified	On	Data is being transmitted
TX	Unidentified	Off	Data is not being transmitted
RX	Unidentified	On	Data is being received
RX	Unidentified	Off	Data is not being received
COL	Unidentified	On	Collision detected on network
COL	Unidentified	Off	No collision detected on network
100M	Unidentified	On	Transceiver is in 100Mbps mode
100M	Unidentified	Off	Transceiver is in 10Mbps mode