AR-200 Network Card Settings and Configuration

NIC Type	Token Ring
Transfer Rate	4/16Mbps
Data Bus	16-bit ISA
Topology	Ring
Wiring Type	AUI transceiver via DB-15 Shielded/Unshielded twisted pair
Boot ROM	In firmware

CABLE TYPE
Type	JP1 - JP4
AUI transceiver via DB-15	Open
Unshielded twisted pair	Closed

MULTIPLE CARD CONFIGURATION
AR-200		SW1/9
»	Primary	On
	Alternate	Off
Note:If the AR-200 is the only card installed, use the "Primary setting".

INTERRUPT REQUEST
IRQ		SW1/7	SW1/8
»	2	Off	Off
	3	Off	On
	7	On	On

NETWORK SPEED
Speed		SW1/12
»	16Mbps	On
	4Mbps	Off
Note:All cards on a segment must have this option set the same.

ROM ADDRESS
Address	SW1/1	SW1/2	SW1/3	SW1/4	SW1/5	SW1/6
A0000h	Off	On	Off	Off	Off	Off
A4000h	Off	On	Off	Off	On	Off
A8000h	Off	On	Off	On	Off	Off
AC000h	Off	On	Off	On	On	Off
B0000h	Off	On	On	Off	Off	Off
B4000h	Off	On	On	Off	On	Off
B8000h	Off	On	On	On	Off	Off
BC000h	Off	On	On	On	On	Off
C0000h	On	Off	Off	Off	Off	Off
C4000h	On	Off	Off	Off	On	Off
C8000h	On	Off	Off	On	Off	Off
CC000h	On	Off	Off	On	On	Off
D0000h	On	Off	On	Off	Off	Off
D4000h	On	Off	On	Off	On	Off
D8000h	On	Off	On	On	Off	Off
DC000h	On	Off	On	On	On	Off
E0000h	On	On	Off	Off	Off	Off
E4000h	On	On	Off	Off	On	Off
E8000h	On	On	Off	On	Off	Off
EC000h	On	On	Off	On	On	Off
F0000h	On	On	On	Off	Off	Off

SHARED RAM CONFIGURATION
Size		SW1/10	SW1/11
»	16KB	On	Off
	8KB	Off	Off
	32KB	Off	On
	64KB	On	On
Note:This setting configures how much system memory the card will use.