LANSTOR EISA RAIDCARD Hard Disk/Floppy Controller Settings and Configuration

Card Type	Hard drive controller
Processor	Unidentified
Chipset:	Unidentified
Maximum On Board Memory	32MB
Hard Drives Supported	Up to 7 SCSI-2 Fast devices
	Up to 7 SCSI-2 Wide devices
Floppy Drives Supported	None
Data Bus	32-bit EISA
Card Size	Full length, full height
Raid Levels Supported	0, 1, 3, 5, 6, 7

MAINBOARD CONNECTIONS
Function	Location	Function	Location
2-pin connector - status LED	J2	68-pin SCSI Wide connector - internal	P3
2-pin connector - EISA activity LED	J3	50-pin SCSI Fast connector - internal	P4
2-pin connector - SCSI activity LED	J5	SCSI connector - external	P5
Daughter board connector	P2

DAUGHTER BOARD CONNECTIONS
Function	Location	Function	Location
Optional power connector for SCSI terminators	J2	68-pin SCSI Wide connector - internal	P2
Main board connector	P1	50-pin SCSI Fast connector - internal	P3
Note:Diagram not available for daughter board.

USER CONFIGURABLE SETTINGS
Function		Label	Position
	MAIN BOARD SETTINGS
»	Factory configured - do not alter	J1	Closed
»	Factory configured - do not alter	J4	Open
»	Factory configured - do not alter	J6	Open
»	Factory configured - do not alter	J7	Pins 2 & 3 closed
Note:Location of J1 and J4 is unidentified.

USER CONFIGURABLE SETTINGS (CON’T)
Function		Label	Position
	DAUGHTER BOARD SETTINGS
»	Factory configured - do not alter	J1	Unidentified
	Termination enabled	J3	Closed
	Termination disabled	J3	Open

TERMINATION POWER SELECTION
Setting		J8
»	TERMPWR supplied to SCSI interface	Closed

DRAM CONFIGURATION
Size	Bank 0
4MB	(4) 1M x 9
16MB	(4) 4M x 9
32MB	(4) 8M x 9