AT ADAPTER BOARD Hard Disk/Floppy Controller Settings and Configuration
CONNER PERIPHERALS, INC.
AT ADAPTER BOARD
Data bus: 16-bit, ISA
Size: Half-length, full-height card
Hard drives supported: Two IDE Interface (AT) drives
Floppy drives supported: None
CONNECTIONS | |
Function | Location |
40-pin IDE Interface (AT) connector-internal | CN1 |
USER CONFIGURABLE SETTINGS | |||
Function | Location | Setting | |
| » | Hard drive port address is 1F0-1F7h | JP1 | open |
Hard drive port address is 170-177h | JP1 | closed | |
| » | Chip Select 1 (CS1) enabled | JP2 | closed |
Chip Select 1 (CS1) disabled | JP2 | open | |
| » | IRQ14 is cleared with a status read only | JP3 | pins 2 & 3 closed |
IRQ14 is cleared with deassertion of Host Slv/Act | JP3 | pins 1 & 2 closed | |
My Books
