WA6 Hard Disk/Floppy Controller Settings and Configuration
80 DATA
WA6
Data bus: | 16-bit ISA |
Size: | Three-quarter length, full-height card |
Hard drive supported: | Two ST506/412 drives (encoding method unidentified) |
Floppy drives supported: | Tw0 360KB, 720KB drives |
CONNECTIONS | |
Function | Location |
4-pin connector - drive active LED | CN1 |
20-pin data cable connector - drive 1 | CN2 |
20-pin data cable connector - drive 0 | CN3 |
34-pin control cable connector - hard drive | CN4 |
34-pin control cable connector - floppy drive | CN5 |
USER CONFIGURABLE SETTINGS | ||
Function | Location | Setting |
Hard drive uses primary address | JP1/A | open |
Hard drive uses alternate address | JP1/A | closed |
Floppy drive uses primary address | JP1/B | open |
Floppy drive uses alternate address | JP1/B | closed |
Floppy drive 360 RPM mode enabled | JP2 | pins 1 & 2 closed |
Floppy drive 300 RPM mode enabled | JP2 | pins 2 & 3 closed |
Latched mode enabled | JP3/A | open |
Non-latched mode enabled | JP3/A | closed |
4 byte error correction enabled | JP3/B | open |
7 byte error correction enabled | JP3/B | closed |
Caching enabled | JP3/C | open |
Caching disabled | JP3/C | closed |
My Books
