PENRIL DATABILITY NETWORKS
DX V.32TERBO M
Modem Type | Data (synchronous/asynchronous)/Fax |
Maximum Data Rate | 19.2Kbps |
Maximum Fax Rate | 14.4Kbps |
Data Bus | External |
Fax Class | Class I & II |
Data Modulation Protocol | Bell 103A/212A, 208A/B ITU-T V.21, V.22, V.22bis, V.23, V.32, V.32bis, V.32terbo |
Fax Modulation Protocol | ITU-T V.17, V.27ter, V.29 |
Error Correction/Compression | MNP5, V.42, V.42bis |
CONNECTIONS | |||
Purpose | Location | Purpose | Location |
Lease line out | CN1 | Diagnostic connector | CN4 |
Line in | CN2 | AC power | CN5 |
RS-232/422 | CN3 | Data/Voice | BT1 |
A/A1 - MI/MIC CONTROL | ||
Control Type | JP3 | JP4 |
» A/A1 control. | Pin 1 & 2 closed. | Pin 1 & 2 closed. |
MI/MIC control. | Pin 2 & 3 closed. | Pin 2 & 3 closed. |
DIAL/LEASE LINE | ||
Line Type | JP1 | JP2 |
» Dial line connected. | Pin 1 & 2 closed. | Pin 1 & 2 closed. |
Lease line connected. | Pin 2 & 3 closed. | Pin 2 & 3 closed. |
DTE CONNECTION - PIN 25 | |
Function | JP6 |
Analog loopback (input). | Pin 1 & 2 closed. |
» Test mode indicator (output). | Pin 2 & 3 closed. |
FACTORY CONFIGURED SETTINGS - DO NOT ALTER | |
Jumper | Setting |
JP5 | Pin 2 & 3 closed. |
FRAME/SIGNAL GROUND | |
Ground Type | JP7 |
Frame and signal ground connected. | Pin 1 & 2 closed. |
» Frame and signal ground not connected. | Pin 2 & 3 closed. |
DIAGNOSTIC LED(S) | |||
LED | Color | Status | Condition |
HS | Red | On | Modem is operating at 7200bps or faster |
HS | Red | Off | Modem is operating at slower than 7200bps |
AA | Red | On | Auto-answer enabled |
AA | Red | Off | Auto-answer disabled |
AA | Red | Blinking | Phone is ringing |
CD | Red | On | Carrier signal detected |
CD | Red | Off | Carrier signal not detected |
OH | Red | On | Modem is off-hook |
OH | Red | Off | Modem is on-hook |
RD | Red | On | Modem is receiving data |
RD | Red | Off | Modem is not receiving data |
SD | Red | On | Modem is transmitting data |
SD | Red | Off | Modem is not transmitting data |
TR | Red | On | DTR signal is high |
TR | Red | Flashing | Voice mode |
MR | Red | On | Modem ready |
MR | Red | Flashing | Test mode enabled |
Proprietary AT Command Set
See document V1410 for a full command summary.