14V14XV modem/telephone/ISDN Settings and Configuration
LOGICODE TECHNOLOGY, INC.
14V14XV
Modem Type | Data (synchronous/asynchronous)/Fax/Voice |
Maximum Data Rate | 14.4Kbps |
Maximum Fax Rate | 14.4Kbps |
Data Bus | External |
Fax Class | Class I & II |
Data Modulation Protocol | Bell 103A/212A ITU-T V.21, V.22, V.22bis, V.32, V.32bis |
Fax Modulation Protocol | ITU-T V.17, V.21CH2, V.27ter, V.29 |
Error Correction/Compression | MNP10, MNP5, V.42, V.42bis |
CONNECTIONS | |||
Purpose | Location | Purpose | Location |
Line out | CN1 | Speaker | CN5 |
Line in | CN2 | Microphone | CN6 |
RS-232/422 | CN3 | Power switch | SW1 |
DC power | CN4 | ||
DIAGNOSTIC LED(S) | |||
LED | Icon | Status | Condition |
AA | AA | On | Auto-answer enabled |
AA | AA | Off | Auto-answer disabled |
AA | AA | Blinking | Phone is ringing |
ST | Pyramid of balls | On | Self test mode |
ST | Pyramid of balls | Off | Normal operation |
ST | Pyramid of balls | Blinking | Self test failure |
RX | Modem left arrow | On | Modem is receiving data |
RX | Modem left arrow | Off | Modem is not receiving data |
TX | Modem right arrow | On | Modem is transmitting data |
TX | Modem right arrow | Off | Modem is not transmitting data |
CD | Phone | On | Carrier signal detected |
CD | Phone | Off | Carrier signal not detected |
HS | Running figure | On | Modem is operating at 4800bps or faster |
HS | Running figure | Off | Modem is operating at slower than 4800bps |
OH | Crossed out phone | On | Modem is off-hook |
OH | Crossed out phone | Off | Modem is on-hook |
TR | Box | On | DTR signal is high |
TR | Box | Off | DTR signal is low |
MS | Box | On | Modem connected at more than 24Kbps |
MS | Box | Off | Modem connected at less than 24Kbps |
MR | Rectangle | On | Power is on |
MR | Rectangle | Off | Power is off |
Proprietary AT Command Set
See document V1275 for a full command summary.
My Books
