DIALOGIC CORPORATION
D/240SC-T1, D/300SC-E1, DTI/241SC, DTI/301SC (COAXIAL VERSIONS)
Card Type | Telephony, T1 or E1 CSU/DSU |
Chipset | Unidentified |
I/O Options | PEB/SCbus connector |
T1/E1 Transfer Rate | 1.544Mbps/2.048Mbps |
T1/E1 Protocol | Unidentified |
Frame Type | Unidentified |
Data Bus | 16-bit ISA |
Card Size | Full height, full length |
CONNECTIONS | |||
Function | Label | Function | Label |
T1 or E1 interface | P1 | PEM bus/SCbus connector | P5 |
T1 or E1 interface | P2 |
USER CONFIGURABLE SETTINGS | |||
Setting | Label | Position | |
Transmit coaxial connector shield is grounded | J100A | Closed | |
Transmit coaxial connector shield is not grounded | J100A | Open | |
Receive coaxial connector shield is grounded | J100B | Closed | |
Receive coaxial connector shield is not grounded | J100B | Open | |
» | Board is not in loopback test mode | SW101 | Off |
Board is in loopback test mode | SW101 | On |
PEB BUS TERMINATION | |
Setting | XT |
Not terminated | Not installed |
Terminated as Network Module | Position A |
Terminated as Resource Module | Position B |
BOARD NUMBER SELECTION | |
Setting | SW1 |
1 | Position 0 |
2 | Position 1 |
3 | Position 2 |
4 | Position 3 |
5 | Position 4 |
6 | Position 5 |
7 | Position 6 |
8 | Position 7 |
9 | Position 8 |
10 | Position 9 |
11 | Position A |
12 | Position B |
13 | Position C |
14 | Position D |
15 | Position E |
16 | Position F |
DIAGNOSTIC LED(S) | |||
LED | Color | Status | Condition |
D1 | Red | On | Valid clock signal not being received |
D1 | Red | Off | Valid clock signal being received |
D2 | Yellow | On | Signal has lost frame synchronization |
D2 | Yellow | Off | Signal has not lost frame synchronization |
D3 | Green | On | Valid T1/E1 signal being received |
D3 | Green | Off | Valid T1/E1 signal not being received |
D4 | Unidentified | On | Board is in loopback test mode |
D4 | Unidentified | Off | Board is not in loopback test mode |