ST10 Hard Disk/Floppy Controller Settings and Configuration
SEAGATE TECHNOLOGY, INC.
ST10
Data bus: 8-bit, ISA
Size: Half-length, full-height card
Hard drives supported: Two MFM ST506/ST412 drives
Floppy drives supported: None
CONNECTIONS | |
Function | Location |
20-pin data cable connector-drive 0 | J1 |
20-pin data cable connector-drive 1 | J2 |
34-pin control cable connector-hard drive | J3 |
BIOS ADDRESS | |||
Address | Jumper JP2A | Jumper JP2B | Jumper JP2C |
C8000h | closed | open | open |
D0000h | closed | open | closed |
D8000h | closed | closed | open |
F4000h | closed | closed | closed |
Disabled | open | open | open |
MISCELLANEOUS TECHNICAL NOTES |
This controller has a built-in low-level format program. To enter the program run the DEBUG utility supplied with DOS and at the prompt enter: G=C800:5. |
My Books
