WSU-423S Hard Disk/Floppy Controller Settings and Configuration

Card Type	Controller
Processor	80186
Processor Speed	20MHz
Chip Set	Unidentified
Data Bus	EISA
Hard Drives Supported	SCSI devices SCSI-3 devices
Floppy Drives Supported	Unidentified

CONNECTIONS
Function	Label	Function	Label
Unidentified	J1	68-pin SCSI-3 connector - internal	J4
Unidentified	J2	68-pin SCSI-3 connector - external	J5
50-pin SCSI connector - internal	J3	Unidentified	WS

USER CONFIGURABLE SETTINGS
Setting		Label	Position
»	Active termination for 50-pin SCSI connector enabled	W1	Closed
	Active termination for 50-pin SCSI connector disabled	W1	Open
»	Active termination for 68-pin internal SCSI connector enabled	W2	Closed
	Active termination for 68-pin internal SCSI connector disabled	W2	Open
»	Active termination for 68-pin external SCSI connector enabled	W3	Closed
	Active termination for 68-pin external SCSI connector disabled	W3	Open

SCSI TERMINATION
J3	J4	J5	RP1	RP2	RP3
Used	Not used	Not used	Not installed	Installed	Installed
Used	Used	Not used	Installed	Not installed	Not installed
Used	Not used	Used	Installed	Not installed	Not installed
Not used	Used	Not used	Installed	Installed	Installed
Not used	Used	Used	Not installed	Not installed	Not installed
Not used	Not used	Used	Installed	Installed	Installed

DIAGNOSTIC LED(S)
LED	Color	Status	Condition
LED1	Unidentified	On	Card is not functioning or improperly terminated
LED1	Unidentified	1 blink	ROM failed self-test
LED1	Unidentified	2 blinks	RAM failed self-test
LED1	Unidentified	3 blinks	SCSI controller chip or interface failed self-test
LED1	Unidentified	4 blinks	Internal data bus failed self-test
LED1	Unidentified	5 blinks	Internal address bus failed self-test
LED1	Unidentified	6 blinks	Bus controller chip failed self-test
LED1	Unidentified	Blinking	Fuse is blown
LED1	Unidentified	Off	Card is functioning normally